Auto-Launching The Uca Client Application; Staging And Localization - Motorola CA50 Developer & User Manual

12 - 6 CA50/UCA Client & Server Developer & User Guide
•
Click the Next button.
•
Select the appropriate Network Access Setting for your environment where this network access setting
must be configured to persist across a cold boot.
•
Select the appropriate Relay Server for your environment.
•
Select the UCA Client Setup-UCA.setting.xml for the additional setting.
•
Click the Next button.
•
Click the User-Defined button.
•
Select Stage CA50 for the bundle.
•
Click the Next button.
•
Deselect any bar code configuration you do not wish to use.
•
Click the Finish button.
Refer to MSP documentation to print RD bar codes from the staging profile called Stage the CA50. Refer to
Appendix F, Rapid Deployment

Auto-launching the UCA Client Application

The CA50 can be programmed to automatically launch directly into the UCA client application with no user
intervention by selecting reboot and setting the type of reboot to Warm (as directed in bullet 15 under
MSP bundle).
NOTE For auto-launch to take effect, the entire staging process, through and including
profile, must be completed.
When the type of reboot is set to Warm, auto-launch into the UCA client application is activated in the following
conditions:
•
after scanning RD bar codes
•
after performing a warm boot
•
after performing a cold boot
•
after removing/inserting a battery.

Staging and Localization

If the CA50 device is staged using MSP versions prior to MSP 3.2.1, the language option does not appear in the
UCA settings and the CA50 device does not receive language information during the staging process. The CA50
login screen displays in English only. After the device logs in, all display switch to the language set during the
installation of UCA server software.
to use Rapid Deployment on the CA50.
Creating an
Creating an MSP staging