Table of Contents
Advertisement
3 - 4
CA50/UCA Client & Server Developer & User Guide
Preparing the CA50 for Use
To prepare the CA50 for first time use:
•
Install the battery.
•
Charge the CA50 (charge spare batteries as needed).
•
Configure the CA50 device via Rapid Deployment bar codes (see
NOTE When Rapid Deployment completes device configuration, the device has a valid network configuration and
the UCA client application communicates with a UCA server (assuming a valid UCA server address is
contained within the Rapid Deployment bar codes).
RF settings and settings to communicate to the UCA server can be set several ways: by scanning one set
of bar codes that configure both RF and UCA server settings; by scanning two separate sets of bar codes,
one containing RF settings, the other containing UCA server settings; or, by scanning one set of RF
parameters and setting the UCA server through an On Demand server function of MSP.
To completely update a CA50 device, up to three sets of Rapid Deployment bar codes may need scanning.
When Rapid Development is complete, cold boot the CA50 to boot up into the UCA client application at
which time the device communicates to the server and receives the login screen.
Charge the battery before or after it is installed. Use one of the spare battery chargers to charge the battery (out of
the CA50), or one of the CA50 device chargers to charge the battery installed in the CA50.
Inserting and Removing the Battery
Inserting the Battery
Before using the CA50, insert the lithium-ion battery provided with the device.
Insert the battery, bottom first, into the battery compartment in the back of the device.
1.
Press the battery down into the battery compartment until the battery release latch snaps into place.
2.
Release Latch
Inserting the Battery
Figure 3-3
NOTE Position the battery correctly, with the battery charging contacts pointing towards the bottom of the CA50.
Battery
Appendix F, Rapid
Deployment).
click
Advertisement
Table of Contents
Troubleshooting
