Service Bit Menu - Oki MC561 Maintenance Manual

Oki Data CONFIDENTIAL

5.2 Service Bit Menu

Additional Fax Setting menu
(When setup ServiceBit=ON, the following items will be displayed at Asmin Setup→Fax
Setup)
# Item Settings
1 Service Bit ON If set OFF, some menu items are not
OFF displayed on the panel.
It will be shown when OKIUSER set on
except for JP1, JPOEM1.
2 Country Code U.S.A. Select the country in which the
International PX736MFP is going to be installed.
United Kingdom When the desired country code is
Ireland selected by this setting, the PTT
Norway parameters that are
Sweden suited to the target country are set.
Finland In this setting, any country code can be
Denmark selected regardless of the OKIUSER
Germany setting.
Hungary
Czech/Slovakia
Poland
Switzerland
Austria
Belgium
Netherlands
France
Portugal
Spain
Italy
Greece
Australia
New Zealand
Singapore
Hong Kong
Latin America
Mexico
China
Russia
Taiwan
Japan
44473001TH Rev.1
Description ODA OEL
OFF OFF OFF
USA Intl Japan
# Item Settings
3 Korea
Thailand
Malaysia
Jordan
JP1
Argentina
Brazil
South Africa
Belarus
Moldova
Turkey
Ukraine
4 A/R Full Print ON
OFF
5 Tone For Enable
Echo (For Disable
Transmission)
6 Tone For Echo Enable
(For Reception) Disable
7 Attenuator 0~15 dB
8 MF Attenuator 0~15 dB
9 Pulse Make 33%
Ratio 39%
40%
10 Pulse Dial Type N
10-N
N+1
11 MF(Tone) 75, 85, 100
Duration mseconds
12 Calling Timer 1~255 second
(s)
5. MAINTENANCE MENUS
Description ODA
It only shows, when ServiceBit = ON. ON
It only shows, when ServiceBit = ON. Disable Disable Disable
It only shows, when ServiceBit = ON. Disable Disable Disable
Enter Attenuator. Depends on Country Code
It only shows, when ServiceBit = ON.
Enter MF (Tone) Attenuator. Depends on Country Code
It only shows, when ServiceBit = ON.
Depends on Country Code
Sets the make rate of DP (10 pps)
during call.
It only shows, when ServiceBit = ON
and Tone/Pulse setting = PULSE.
Depends on Country Code
Enter MF (Tone) Duration. Depends on Country Code
It only shows, when ServiceBit = ON
and Tone/Pulse setting = TONE.
Sets the call connection wait time (TO Depends on Country Code
timer). When the setting value is "0",
the MFP runs at the initial value of
each country. When any value other
than "0" is set, the call connection wait
time (TO timer) can be selected in the
range of 1 to 255 mm.
It only shows, when ServiceBit = ON.
OEL JP1
ON ON
148 /