Oki MC561 Maintenance Manual page 142

Oki Data CONFIDENTIAL
Item1 Item2 Item3
Password ADF Adjust Scan
(Back-side) Position
Adjust Mech.
44473001TH Rev.1
Item4 Item5 Value
ADF Side Reg. +8 ~ -8 mm
(Front-side)
Front Edge +30 ~ -30 mm
Back Edge +30 ~ -30 mm
ADF Front Edge +30 ~ -30 mm
(Back-side)
Back Edge +30 ~ -30 mm
Adjust +30 ~ -30 mm
ADF Scan
Position
Adjust FB Drive 1 ~ 140
Mech. Current
FB Keep 1 ~ 140
Current
ADF Drive 1 ~ 140
Current
ADF Keep 1 ~ 140
Current
Default Default Default
value value value
ODA OEL JP
0 0 0 Adjust the starting read pixel position in the horizontal scanning direction when reading
a document from the ADF.
Adjust in intervals of one step = 4/600 dpi (=0.17 mm).
0 0 0 When reading a document from the ADF, add a value for the basic value when reading
the shadow of the front edge of the document. To skip the front edge of the document,
add a negative value.
Increase or decrease the number of motor pulses from detection by the sensor of the
front edge of the media until actual reading starts.
Adjust in intervals of one step = 4/600 dpi (= 0.17 mm).
0 0 0 When reading a document from the ADF, add a value for the basic value when skipping
the back edge of the document. To read the shadow of the back edge of the document,
add a negative value.
Increase or decrease the number of motor pulses from detection by the sensor of the
back edge of the media until actual reading ends.
Adjust in intervals of one step = 4/600 dpi (= 0.17 mm).
0 0 0 When reading a document from the ADF, add a value for the basic value when reading
the shadow of the front edge of the document. To skip the front edge of the document,
add a negative value.
Increase or decrease the number of motor pulses from detection by the sensor of the
front edge of the media until actual reading starts.
Adjust in intervals of one step = 4/600 dpi (= 0.17 mm).
0 0 0 When reading a document from the ADF, add a value for the basic value when skipping
the back edge of the document. To read the shadow of the back edge of the document,
add a negative value.
Increase or decrease the number of motor pulses from detection by the sensor of the
back edge of the media until actual reading ends.
Adjust in intervals of one step = 4/600 dpi (= 0.17 mm).
0 0 0 Set the CIS reading position of the ADF for the focusing standard.
Adjust in intervals of one step = 4/600 dpi (= 0.17 mm). This is correlated to adjustment
of the ADF front edge position.
Connect a panel or PC and set the electric current value of the scanner motor.
5. MAINTENANCE MENUS
Notes
142 /