Table of Contents
Advertisement
Optional Equipment
6. Disconnect the regulator wire from the IFC. Pinch the tab on the wire connector to release.
7. The stepper motor (adjustable regulator) has an installation sheet included with it – make sure to
follow all of the directions. Place the stepper motor on the gas control valve– MAKE SURE IT IS
CORRECTLY ORIENTED. Secure using the screws included with the motor– tighten to 25 Lb-
inches. Leak test this area after installation to verify proper installation.
8. Install the burner (see the instructions included with the burner). Replace the glass and restore
the fireplace to the correct configuration.
© Travis Industries
(
for qualified installers only)
4141013
45
100-01414
Hide quick links:
Advertisement
Table of Contents
