Table of Contents
Advertisement
STEP H:
Using the 1/4-20 x 1/2" Hex Head Bolt,
Hex Nut, and two (2) Flat Washers, securely attach
the Adjustable Anti-Tip Channel to the existing
hole in the flange located at the bottom rear of the
range. (There are two holes in the range flange, so
be certain to select the hole that is on the same
side as the mounting bracket.) The flat face of the
channel should be flush against the underside of
the range flange.
From the bottom of the channel,
screw the two (2) #10 x 1/2" Phillips Screws up through
holes extending beyond the rear
the first pair of
edge of the range flange. These screws will prevent
rotation of the channel. Note: A number of
mounting holes are provided in the Adjustable
Anti-Tip Channel. Be certain to use the hole
that enables the channel to engage the mount-
ing bracket when the range is in its final
installed position. For ranges that are to be
installed flush against a rear wall, use the
first hole in the Adjustable Anti-Tip Channel,
such that the short portion of the channel
extends out from the bottom of the range
flange and the long portion is hidden beneath
the range. Refer to Figure 10.
STEP I:
Carefully slide the range into position. FOR
THE ANTI-TIP CHANNEL TO ENGAGE THE
MOUNTING BRACKET, THE REAR EDGE OF THE
RANGE SIDE PANEL MUST BE WITHIN 2" OF THE
VERTICAL MOUNTING FLANGE OF THE ANTI-TIP
BRACKET, AND THE ADJUSTABLE MOUNTING
CHANNEL MUST BE ATTACHED TO THE APPRO-
PRIATE MOUNTING HOLE. REMOVE ANY LOOSE
ITEMS SUCH AS GRATES AND BURNER CAPS
FROM THE TOP OF THE RANGE, THEN CARE-
FULLY TILT THE RANGE FORWARD TO ENSURE
THAT THE ANTI-TIP DEVICE ENGAGES TO PRE-
VENT TIPPING.
PRSE304 and PRSE36 Dual-Fuel Ranges (Figures 11, 14 and 15)
STEP A:
Determine the best location for the
Anti-Tip Channel/Mounting Bracket. The
bracket may be mounted to the wall or floor
behind the range, off-set from the side wall as
indicated in the chart below and in Figures 14
and 15:
Model No.
PRSE304
PRSE36
•
For Model PRSE304, the dimensions shown
are from the left side wall only.
•
For Model PRSE36, the dimensions shown
"A", Min.
"B", Max.
5-1/2"
16-1/2"
6-1/2"
13-1/2"
STEP 4: INSTALLING ANTI-TIP DEVICE
FIG. 13 PRSG Floor Mount
PLAN VIEW
May Be used On
Either Left or Right
(Right Shown)
SIDE VIEW
are from the left or right side wall. Locate the
bracket on the side that will not interfere with
the gas supply line, electrical wiring, conduit,
or any other item.
•
Select either the rear wall or the floor for
mounting the bracket, based upon which will
provide the greatest holding strength.
Page 13
PRSG304: 2-3/4"
7/16"
PRSG36: 4-5/8"
Hide quick links:
Advertisement
Table of Contents
