Thermador PRSG304 Installation Instructions Manual page 11

Parts Required for Installation of Anti-Tip Device:
PRSG304 and PRSG36 All-Gas Ranges (Figures 9 and 10)
Thermador Part No. Qty.
15-10-916 4
15-10-771 1
15-10-772 1
15-10-909 1
15-10-910 1
15-10-911 2
15-10-948 2
FIG. 10. Adjustable Anti-Tip Channel PRSG304 and PRSG36
All-Gas Ranges
This Hole For Flush
Mount of PRSG304
1-9/32"
PRSE304 and PRSE36 Dual-Fuel Ranges
(Figure 11)
Thermador Part No. Qty.
15-10-916 4
15-10-770 1
IMPORTANT INSTALLATION INFORMATION:
• The anti-tip bracket may be attached to a solid
wood cabinet having a minimum wall thickness
of 3/4".
• The thickness of the wall or floor may require use
of longer screws available at your local hardware
store.
• In all cases, at least two (2) of the bracket
mounting screws must be fastened to solid wood
or metal.
• Use appropriate anchors when fastening the
mounting bracket to any material other than
hardwood or metal.
• Prepare holes at fastener locations as identified
below:
- For walls, wall studs, or floors composed of
solid wood or metal, drill 1/8" pilot holes.
STEP 4: INSTALLING ANTI-TIP DEVICE
Description
Screw, Phillips, #10 x 1-1/2"
Anti-Tip Channel, Adjustable,
PRSG
Mounting Bracket, PRSG
Bolt, Hex Head, 1/4-20 x
1/2"
Nut, Hex, 1/4-20
Washer, Flat, 1/4-20
Screw, Phillips, #10 x 1/2",
Type B
5-1/2"
This Hole For Flush
Mount of PRSG36
1-17/32"
Description
Screw, Phillips, #10 x
1-1/2 "
Anti-Tip Channel/
Mounting Bracket
Page 11
FIG. 9. Mounting Kit for PRSG304 and
PRSG36 All Gas Ranges
15-10-772 (1 Each)
15-10-909 (1 Each))
15-10-948 (2 Each)
FIG. 11. Mounting Kit for PRSE304 and
PRSE36 Dual-Fuel Ranges
15-10-770 (1 Each )
- For walls or floors composed of drywall,
sheet-rock, or other soft materials, drill 3/
16" holes to a minimum depth of 1-3/4", then
tap plastic anchors into each of the holes
using a hammer.
- For walls or floors composed of concrete or
concrete block, drill 3/16" holes to a mini-
mum depth of 1-3/4", then tap concrete
anchors into each of the holes using a
hammer.
- For walls or floors having ceramic tile cover-
ings, drill 3/16" holes through the tile only,
then drill into the material behind the tile as
indicated immediately above.
• If the range is moved to a new location, the Anti-
Tip Device must be removed and reinstalled.
15-10-916 (4 Each)
15-10-771 (1 Each)
15-10-911 (2 Each)
15-10-910 (1 Each)
15-10-916 (4 Each)