Scrub Brushes; Finished Floors; Recovery Tank Float Shut-Off - Windsor Saber Cutter SCX264 Operating Instructions Manual

Maintenance

Scrub Brushes

There are four different types of brushes available to
cover applications from cleaning heavily soiled floors to
polishing. A pad driver is also available to take
advantage of the many cleaning pads on the market.
Please refer to the following to assist in selecting the
proper brush or pad for the work at hand.
Uncoated Floors
Aggressive Grit is a nylon fiber impregnated with
silicone carbide grit. It grinds away stain, soil, and
removes surface material.
Mild Grit is a less aggressive silicone carbide grit
suitable for cleaning medium soil conditions. Advan-
tages are faster ground speed than nylon bristles on
light solid applications.
Polypropylene is a general-purpose scrub brush with
stiff bristles. Polypropylene works well for maintaining
concrete, wood and tile floors.

Finished Floors

Nylon bristles are used in a variety of applications on
coated or uncoated surfaces.
White Pads (Polishing) are used for dry polishing to
achieve a high-gloss appearance, or surface washing
on highly polished or burnished floors.
Red Pads (Buffing) are used for light-duty scrubbing.
When used with a mild detergent they will provide
surface cleaning without removing the finish.
Blue Pads (Scrubbing) are used for heavy-duty
scrubbing and light stripping. The blue pads remove
less finish than brown stripping pads, yet will remove
black marks, stains and dirt.
Black Pads (Stripping) are used for easy and complete
removal of old floor waxes/finishes. They will quickly
remove ground in dirt, black heel marks, and spills.
When used with the proper stripper, this pad leaves the
floor clean and ready for finishing.
The scrub brushes should be checked before each
days work for wire, string, wear and damage.
28
Replacing Or Installing Scrub Brushes
1. With the scrub deck up, turn "OFF" the machine.
2. Remove the two brush cover shrouds.
3. Locate release lever on top of brush or pad driver.
4. To reinstall, center the brush driver under the brush
5. Replace the two brush cover shrouds.

Recovery Tank Float Shut-off

When water is no longer being vacuumed from the floor
and the vacuum fan is operating, the ball float has
engaged. The vacuum motor will not vacuum water
with recovery tank full. The recovery tank must be
drained.
1. The float shut-off screen can be cleaned in or out
2. To clean the float shut-off while it is inside the
3. To remove the float shut-off, grasp the screen with
To install, place one hand on the tube, and then tilt
and push the float screen assembly over the barb on
the tube.
86400260 Manual Operators - Cutter 24V Deluxe
FOR SAFETY: Before leaving or servicing the
machine; stop on level surface, turn OFF machine
and remove key.
Rotate release lever counter-clockwise and the
brush/pad driver will release and drop down.
drive hub. Raise until it contacts brush driver
assembly. Turn clockwise until release lever plate
locks into position.
NOTE: Check that release plate is completely closed
and pad/brush is securely attached. Damage to driver
or brush could occur.
of the machine.
machine wipe material off screen then rinse. Check
that the ball is also clean and moves freely.
one hand and the connected tube with the other.
Tilt and pull the float screen assembly to pull it off
the barb on the tube.