Transport, Storage And Disposal; 11.1 Venting The Appliance - Melitta Caffeo Varianza CSP Operating Instructions Manual

Problem
The My Bean Select
display goes out
when the measuring
spoon is put back on.
Fill beans appears on
the display although
the bean container
is full.
Loud grinder noise.
Brewing unit cannot
be inserted after
removing.
System error appears
on the display.
11

Transport, storage and disposal

11.1 Venting the appliance

We recommend venting the appliance when it is not used for a long period,
prior to transport and when there is a risk of frost.
During venting, residual water is removed from the appliance.
Requirement: The ready symbol appears on the display.
1. Place a vessel beneath the outlet.
2. Press the "menu/ok" button for longer than 2 seconds.
» The menu appears on the display.
3. Navigate to the System > Venting menu.
4. Select Start using the arrow buttons and confirm with "menu/ok".
5. Follow the further instructions on the display.
» The appliance switches off.
Cause Action
There are less than 8 ƒ
g of coffee beans in
the bean chute.
Coffee beans do
ƒ
not drop into the
ƒ
grinder.
ƒ
ƒ
Foreign object in the
ƒ
grinder.
Handle for the
ƒ
locking mechanism
of the brewing unit
is not in the correct
position.
Drive is not in the
ƒ
correct position.
Software problem.
ƒ
ƒ
Transport, storage and disposal
Top up coffee beans (see sec-
tion 5.1 one page 23).
Press a direct key.
Tap lightly on the bean container.
Clean the bean container.
Coffee beans too oily. Use different
coffee beans.
Contact the hotline.
Check that the handle for the
locking mechanism is correctly
engaged (see section 9.3 one
page 37).
Press and hold the "Coffee
strength" button. Also press the
ON/OFF button. The appliance
initialises. Release buttons again.
Switch the appliance off and
on again (see section 4.1 one
page 14).
Contact the hotline.
45