Steering mounted controls
Changing the
programmed speed
There are two methods of memorising
a speed higher than the previous one:
Without using the accelerator
-
Press the SET + button.
A brief press increases the speed by 1 mph (km/h).
A maintained press increases the speed in
steps of 5 mph (km/h).
Using the accelerator
-
Exceed the memorised speed until
the speed required is reached,
-
Press the SET + or SET - button.
To memorise a speed lower than the
previous one:
-
Press the SET - button.
a brief press decreases the speed by
1 mph (km/h).
A maintained press decreases the
speed in steps of 5 mph (km/h).
Switching the system off
-
Place the dial in position 0 or switch
off the ignition to switch everything
off.
Cancelling the programmed
speed setting
When the vehicle becomes stationary,
after switching off the ignition, the
system no longer memorises a speed.
Operating fault
The programmed speed setting is
cleared and replaced by three dashes.
Contact a CITRoËn dealer or a
qualified workshop to have the system
checked.
Good practice
When changing the programmed
speed setting by means of a
maintained press, pay attention as
the speed can increase or decrease
rapidly.
do not use the cruise control on
slippery roads or in heavy traffic.
In the event of a steep slope, the cruise
control cannot prevent the vehicle from
exceeding the programmed speed
setting.
In any event, the cruise control cannot
replace the need to observe the speed
limits and the need for vigilance on the
part of the driver.
It is advisable to keep your feet near
the pedals.
To avoid any jamming under the
pedals:
-
ensure that the mat and its fixings
on the floor are positioned correctly,
-
never place one mat on top of
another.