Battery - CITROEN 2015 Berlingo Multispace Handbook

BATTERY

The presence of this label
indicates the use of a 12 V
lead-acid battery with special
technology and specification, for which
the involvement of a CITROËN dealer
or qualified workshop is required when
replacing or disconnecting the battery.
Failure to observe this
recommendation may cause premature
wear of the battery.
After refitting the battery, the Stop &
Start system will only be active after
several hours depending on the
climatic conditions and the state of
charge of the battery (up to about
8 hours).
The Stop & Start battery does not have
to be disconnected for charging.
To charge the battery using a
battery charger
- Disconnect the battery.
- Follow the instructions for use
given by the battery charger
manufacturer.
- Reconnect starting with the
negative (-) terminal.
- Check that the terminals and
connectors are clean. If they are
covered with sulphate (white or
greenish deposit), disconnect them
and clean them.
To start the vehicle from
another battery
- Connect the red cable to the
positive (+) terminals of the
two batteries.
- Connect one end of the green
or black cable to the negative (-)
terminal of the slave battery.
- Connect the other end of the green
or black cable to an earth point on
the broken down vehicle as far as
possible from the battery.
- Operate the starter, let the engine run.
- Wait for the engine to return to idle,
then disconnect the cables.
It is advisable to disconnect the
battery if the vehicle is not to be
used for a period of more than
one month.
Before disconnecting the battery, you
must wait for 2 minutes after switching
off the ignition.
Never disconnect a terminal when the
engine is running.
Never charge a battery without first
disconnecting the terminals.
after every reconnection of the battery,
switch on the ignition and wait 1 minute
before starting to allow the electronic
systems to be initialised. If problems
remain after doing this, please contact
a CITROËN dealer or a qualified
workshop.
after changing bulbs, wait
approximately 3 minutes before
reconnecting the battery.
Battery
8