Completing The Parts Replacement - Lenovo ThinkCentre M700z User Manual

10. Position the Wi-Fi card shield over the Wi-Fi card so that the screw on the shield aligns with the
mounting stud on the chassis. Then, connect the Wi-Fi antenna cables to the Wi-Fi card, and then install
the screw on the Wi-Fi card shield to secure the Wi-Fi card to the system board.
Figure 57. Connecting the Wi-Fi antenna cables and installing the Wi-Fi card shield
11. Install the system-board shield. See "Replacing the system-board shield" on page 66.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 82.

Completing the parts replacement

After completing the installation or replacement for all parts, reinstall the computer cover and reconnect
cables. Depending on the parts you installed or replaced, you might need to confirm the updated information
in the Setup Utility program. Refer to "Using the Setup Utility program" on page 41.
To reinstall the computer cover and reconnect cables to your computer, do the following:
1. Ensure that all components have been reassembled correctly and that no tools or loose screws are left
inside your computer. See "Computer components" on page 7 for the locations of various components
in your computer.
2. Ensure that the cables are routed correctly before reinstalling the computer cover. Keep cables clear of
the hinges and sides of the computer chassis to avoid interference with reinstalling the computer cover.
3. Position the computer cover into place and then tighten the two screws
82
ThinkCentre M700z and M800z User Guide
1 to secure the computer cover.