Lenovo ThinkCentre M700z User Manual page 80

13. Connect the cable to the new storage drive.
14. Install the VESA mount bracket. See "Replacing the VESA mount bracket" on page 68.
15. Install the system-board shield. See "Replacing the system-board shield" on page 66.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 82.
For M800z
To replace the storage drive, do the following:
1. Remove any media from the drives and turn off all connected devices and the computer. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to the
computer.
2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the screen is against the surface and the cover is facing up.
3. Remove the computer stand. See "Replacing the computer stand" on page 60.
4. Remove the computer cover. See "Removing the computer cover" on page 65.
5. Locate the storage drive. See "Computer components" on page 7.
6. Disconnect the signal cable and the power cable from the storage drive.
7. Press the release tab
Figure 36. Removing the storage drive
70
ThinkCentre M700z and M800z User Guide
1 , and then remove the storage drive from the storage drive holder as shown.