Table of Contents
Advertisement
1. Remove any media from the drives and turn off all connected devices and the computer. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to the
computer.
2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the screen is against the surface and the computer cover is facing up.
3. Press the stand latch
the UltraFlex II Stand from the computer cover.
Figure 26. Removing the UltraFlex II Stand from the computer cover
4. Insert the two hooks
as shown. Then, pivot the UltraFlex II Stand downward until it snaps into position.
Figure 27. Installing the UltraFlex II Stand on the computer cover
Replacing the power adapter (for M700z)
Attention: Do not open your computer or attempt any repair before reading and understanding the "Read
this first: Important safety information" on page iii.
To replace the power adapter, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
64
ThinkCentre M700z and M800z User Guide
1
on the UltraFlex II Stand as shown to disengage the latch. Then, remove
1
on the new UltraFlex II Stand into the corresponding holes in the computer cover
Hide quick links:
Advertisement
Table of Contents
