6. Insert the two hooks
computer cover as shown. Then, pivot the full-function monitor stand downward until it snaps into
position.
Figure 21. Installing the full-function monitor stand
Replacing the tilt-only monitor stand
To replace the tilt-only monitor stand, do the following:
1. Remove any media from the drives and turn off all connected devices and the computer. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to the
computer.
2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the screen is against the surface and the computer cover is facing up.
3. Press the retaining latch
the tilt-only monitor stand from the computer cover.
Figure 22. Removing the tilt-only monitor stand from the computer cover
62
ThinkCentre M700z and M800z User Guide
1
on the new full-function monitor stand into the corresponding holes in the
1
on the tilt-only monitor stand as shown to disengage the latch. Then, remove