Supported Processors; General Equipping Rules; Upgrading To Dual Processor Configuration - Fujitsu PRIMERGY RX2530 M1 Upgrade And Maintenance Manual

11.1.1 Supported processors

– up to two Intel
E5-26xxLv3)
– two processor sockets LGA 2011
– supported CPUs from 55 W to 145 W
– core frequencies of more than 3.5 GHz
I
For system relevant information, refer to your server's hardware
configurator available online at the following address:
for the global market:
http://ts.fujitsu.com/products/standard_servers/index.htm
for the Japanese market:
http://jp.fujitsu.com/platform/server/primergy/system/

11.1.2 General equipping rules

Both CPUs must be of the same type.
11.2

Upgrading to dual processor configuration

Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver
V
CAUTION!
– Processors are modules which are extremely sensitive to electro-
static discharges and therefore must always be handled with care.
After a processor has been removed from its protective sleeve or from
its socket, place it with its smooth side down on a non-conducting,
antistatic surface. Never push a processor over a surface.
– Only processors of the same type may be used on the system board.
That means the number of the internal processor cores as well as the
primary clock and the QPI frequency have to be the same.
– For dual operation, use a suitable multiprocessor operating system.
RX2530 M1
®
4-/6-/8-/10-/12-Core processors (Xeon E5-26xxv3 or
Upgrade and Maintenance Manual
Hardware: 15 minutes
Software: 5 minutes
Processors
241