Jenn-Air S136-C Use And Care Manual page 21

7. Push ENTER button to enter stop time.
The indicator word AUTO will blink in the Display Window. When start time
is reached, the indicator word AUTO will remain in Display Window. The oven
indicator light will glow until the desired temperature is reached.
When stop time is reached, the oven shuts off and the indicator word AUTO
will begin to blink and timer will beep. Beeping will continue every 10 seconds
for 15 minutes unless the CANCEL button is pushed twice.
To check START TIME before Cooking begins: Hold in START TIME
button until the words START TIME appear in the Display Window. The start time
will be displayed briefly, then Display will return to time of day.
To change START TIME before cooking begins:
1. Hold in START TIME button until the words START TIME appear in the Display
Window.
2. Turn SET dial to desired time.
3. Push ENTER button twice to enter new start time and stop time previously
programmed.
To check SINI]JP TI[ME: Hold in STOP TIME button until the words STOP TIME
appear in the Display Window. The stop time will be displayed briefly, then Display
will return to on-going program.
To change STOP TIME:
1. Hold in STOP TIME button until the words STOP TIME appear in the Display
Window.
2. Turn SET dial to desired time.
3. Push ENTER button to enter stop time.
To Cancel function programmed:
Push CANCEL button twice to cancel
function, during programmed time or after time has expired.
NOTE: After clock-controlled baking, turn SELECTOR and TEMPERATURE knobs
to OFF position.
NOTE: Since food continues to cook if left in the oven, it is suggested that the
clock controls be used primarily to start the oven when no one is in the
kitchen. Provisions should be made to have the food removed as soon
as the signal has sounded.
NOTE: If more than 7 seconds elapses between holding in START TIME button
or STOP TIME button and turning the SET dial, the display window
will automatically return to on-going program.
NOTE" If more than 1 minute elapses between turning SET dial to a new time
and entering new START TIME and STOP TIME, the entire program
will be cancelled and display will return to time of day clock.
23