Access Point Mode Setup Example
This example uses the network sharing feature in Windows 2000 to bridge the wired and
wireless network when you set the ZyAIR in access point (AP) mode.
Refer to
Chapter 4, "Access Point Mode Configuration," on page 48
requirements.
Steps may vary depending on your Windows version. You may need to install additional
software in Windows 98 Second Edition and Windows ME.
Configuring the Computer on Which You Install the ZyAIR
1 Refer to
AP mode.
2 Click Start, Settings, Network and Dial-up Connections (or click Start, Settings,
Control Panel and double-click Network and Dial-up Connections).
Figure 33 Windows 2000: Start
3 Right-click on the icon for your wired Ethernet adapter and click Properties.
Appendix B Access Point Mode Setup Example
Section 1.6.1 "Change ZyAIR Mode" on page 20
ZyAIR B-220 User's Guide
Appendix B
for setup methods and
to set the ZyAIR to operate in
62