Access Point Mode Setup Example; Figure 54 Windows 2000: Start - ZyXEL Communications G-202 User Manual

Access Point Mode Setup Example

This example uses the network sharing feature in Windows 2000 to bridge the wired and
wireless network when you set the G-202 in access point (AP) mode.
Refer to Chapter 5 on page 73
Steps may vary depending on your Windows version. You may need to install additional
software in Windows 98 Second Edition and Windows ME.
Configuring the Computer on Which You Install the G-202
1 Refer to
2 Click Start, Settings, Network and Dial-up Connections (or click Start, Settings,
Control Panel and double-click Network and Dial-up Connections).

Figure 54 Windows 2000: Start

3 Right-click on the icon for your wired Ethernet adapter and click Properties.
Appendix B Access Point Mode Setup Example
for setup methods and requirements.
Section 1.2.4 on page 23
A
P P E N D I X
to set the G-202 to operate in AP mode.
ZyXEL G-202 User's Guide
B
87