Access Point Mode Setup Example; Figure 35 Windows 2000: Start - ZyXEL Communications G-220 V2 User Manual

Access Point Mode Setup Example

This example uses the network sharing feature in Windows 2000 to bridge the wired and
wireless network when you set the ZyXEL G-220 v2 in access point (AP) mode.
Refer to Chapter 4, "Access Point Mode Configuration," on page 53
requirements.
Steps may vary depending on your Windows version. You may need to install additional
software in Windows 98 Second Edition and Windows ME.
Configuring the Computer on Which You Install the ZyXEL G-
220 v2
1 Refer to
220 v2 to operate in AP mode.
2 Click Start, Settings, Network and Dial-up Connections (or click Start, Settings,
Control Panel and double-click Network and Dial-up Connections).

Figure 35 Windows 2000: Start

3 Right-click on the icon for your wired Ethernet adapter and click Properties.
Appendix B Access Point Mode Setup Example
Section 1.7.1 "Change ZyXEL G-220 v2 Mode" on page 25
ZyXEL G-220 v2 User's Guide
A
P P E N D I X
B
for setup methods and
to set the ZyXEL G-
67