Setting The Auto Power Save Mode - Oki MB770dn User Manual

SETTING ITEMS (ADMIN)
Memo
• If you want to clear an entered time, press the
[CLEAR] button on the control panel.
1
• If you want to put the equipment into the Sleep
mode/the Super Sleep mode for an entire day,
enter the same time in both the [ON] and [OFF]
boxes.
Example) When you enter "0:00" in both the [ON]
and [OFF] boxes for [SUN],
the equipment automatically goes into the Sleep
mode/the Super Sleep mode at the [OFF] time
2 specified for [SAT]. The Sleep mode/the Super
Sleep mode is kept until the [ON] time specified for
[MON] comes.
• If you do not want to put the equipment into the
Sleep mode/the Super Sleep mode for an entire
day, make settings for the desired day of the week
as follows:
[ON]: 0:00 / [OFF]: 24:00
The equipment does not go into the Sleep mode/
3
the Super Sleep mode for an entire day, which is
activated by the weekly timer function. However,
the equipment automatically goes into the Sleep
mode/the Super Sleep mode according to the time
value set for [Auto Sleep mode], if it is left inactive
for a certain period of time.

Setting the Auto Power Save mode

4
1
On the POWER SAVE screen, press [AUTO
POWER SAVE].
The AUTO POWER SAVE screen is displayed.
2
Press the desired period of time (in
minutes) that this equipment should wait
5
before the Power Save mode is activated.
6
The Auto Power Save mode setting is completed, and
you will be returned to the previous screen.
7
Setting the Auto Sleep mode
1
On the POWER SAVE screen, press [AUTO
SLEEP].
The AUTO SLEEP screen is displayed.
2
Specify the following items as required and
complete the setting.
Item name
SLEEP TIMER
SLEEP MODE
Memo
• The settable times are described below.
- 1 min.
- 3 mins.
- 5 mins.
- 10 mins.
- 15 mins.
- 20 mins.
- 25 mins.
- 30 mins.
- 40 mins.
- 50 mins.
- 60 mins.
Note
• The equipment may not enter the Sleep mode at the
set timing depending on its operating status.
• The machine is not switched to the Sleep mode in the
following cases:
- A particular option is installed. (Wireless LAN
module, e-BRIDGE ID Gate)
- The IPsec function is enabled.
- IEEE 802.1X authentication is enabled.
- IPv6 is enabled and the IPv6 address is set other
than manually.
- POP3 client setting is enabled and under any of the
following conditions:
(1) The scan rate is set to other than 0 minute.
(2) A POP3 server address is entered.
(3) An account name is entered.
- A particular network protocol is enabled. (AppleTalk,
IPX/SPX)
• Protocol settings for recovering this equipment from the
Auto Sleep mode are made in the TopAccess
administrator mode. For details, refer to the TopAccess
Guide "Chapter 8: [Administration] Tab Page".
• By default, the Power Save period is set to 1 min and
the Sleep period is set to 1 min.
- 238 -
Description
Select the standby time (mins.) for
the device to switch from standby
mode (idling mode) to the Sleep
mode/the Super Sleep mode.
Select the AUTO, SLEEP, or POWER OFF
mode after the specified [SLEEP TIMER] time.
Select whether the device enters either
sleep mode or super sleep mode
automatically, or turns OFF, when the
period set for sleep ON time has
elapsed. If AUTO is selected, and a fax
is mounted, and the device is connected
to the network, the operations are the
same as when Sleep is selected.