Disassembly
Removing and Replacing the Speaker Assembly
26
To remove the speaker assembly
1.
Follow the procedures to remove the:
•
Battery door
•
Battery
•
SIM card
•
front housing
•
rear housing
2.
Using a Torx driver with a T-6 bit, remove the 2 screws securing the speaker
assembly to the transceiver board.
3.
Lift the assembly off of the transceiver board.)
Figure 11. Removing the Speaker Assembly.
To replace the speaker assembly
1.
Align the speaker assembly with the transceiver board and press it into place.
2.
Insert and tighten the 2screws to a torque setting of 1.2 in/lbs, using the T-6
Torx driver. Do not overtighten.
3.
Follow the procedures to replace the:
•
rear housing
•
front housing
•
SIM card
•
battery
•
battery door
October 4, 2004
E1000
6809490A73