Ipmaps Settings - Motorola 2200 Administrator's Handbook

set ip static-routes destination-network net_address
interface { ip-address | ppp-vccn }
Specifies the interface through which the static route is accessible.
set ip static-routes destination-network net_address
gateway-address gate_address
Specifies the IP address of the Gateway for the static route. The default Gateway must be located on a net-
work connected to the Motorola Netopia® Gateway configured interface.
set ip static-routes destination-network net_address
metric integer
Specifies the metric (hop count) for the static route. The default metric is 1. Enter a number from 1 to 15
for the integer argument to indicate the number of routers (actual or best guess) a packet must traverse to
reach the remote network.
You can enter a metric of 1 to indicate either:
•
The remote network is one router away and the static route is the best way to reach it;
•
The remote network is more than one router away but the static route should not be replaced by a
dynamic route, even if the dynamic route is more efficient.
set ip static-routes destination-network net_address
rip-advertise [ splitHorizon | always | never ]
Specifies whether the gateway should use Routing Information Protocol (RIP) broadcasts to advertise to
other routers on your network and which mode to use. The default is splitHorizon.
delete ip static-routes destination-network net_address
Deletes a static route. Deleting a static route removes all information associated with that route.

IPMaps Settings

set ip-maps name < name > internal-ip < ip address >
Specifies the name and static ip address of the LAN device to be mapped.
set ip-maps name < name > external-ip < ip address >
Specifies the name and static ip address of the WAN device to be mapped.
Up to 8 mapped static IP addresses are supported.
277