Sip Passthrough; Rtsp Passthrough; Static Route Settings - Motorola 2200 Administrator's Handbook

Administrator's Handbook

SIP Passthrough

set ip sip-passthrough [ on | off ]
Turns Session Initiation Protocol application layer gateway client passthrough on or off. The default is on.
Session Initiation Protocol, is a signaling protocol for Internet conferencing, telephony, presence, events
notification and instant messaging.

RTSP Passthrough

set ip ethernet B rtsp-passthrough [ off | on ]
Turns Real Time Streaming Protocol application layer gateway client passthrough on or off. RTSP is a proto-
col used for streaming media. It allows a client remotely to control a streaming media server. A typical
application is Video-on-Demand (VoD). The default is on.

Static Route Settings

A static route identifies a manually configured pathway to a remote network. Unlike dynamic routes, which
are acquired and confirmed periodically from other routers, static routes do not time out. Consequently,
static routes are useful when working with PPP, since an intermittent PPP link may make maintenance of
dynamic routes problematic.
You can configure as many as 32 static IP routes for a Motorola Netopia® Gateway. Use the following com-
mands to maintain static routes to the Motorola Netopia® Gateway routing table:
set ip static-routes
Specifies the network address for the static route. Enter a network address in the net_address argu-
ment in dotted decimal format. The net_address argument cannot be 0.0.0.0.
set ip static-routes
netmask netmask
Specifies the subnet mask for the IP network at the other end of the static route. Enter the netmask argu-
ment in dotted decimal format. The subnet mask associated with the destination network must represent
the same network class (A, B, or C) or a lower class (such as a class C subnet mask for class B network
number) to be valid.
276
destination-network
destination-network
net_address
net_address