How Individual Filters Work; A Filtering Rule; Parts Of A Filter; Port Numbers - Motorola 2200 Administrator's Handbook

How individual filters work
As described above, a filter applies criteria to an IP packet and then takes one of three actions:
•
Forwards the packet to the local or remote network
•
Blocks (discards) the packet
•
Ignores the packet
A filter forwards or blocks a packet only if it finds a match after applying its criteria. When no match occurs,
the filter ignores the packet.
A filtering rule
The criteria are based on information contained in the packets. A filter is simply a rule that prescribes cer-
tain actions based on certain conditions. For example, the following rule qualifies as a filter:
"Block all Telnet attempts that originate from the remote host 199.211.211.17."
This rule applies to Telnet packets that come from a host with the IP address 199.211.211.17. If a match
occurs, the packet is blocked.
Here is what this rule looks like when imple-
mented as a filter in Netopia Embedded Software
Version 7.7.4:
To understand this particular filter, look at the
parts of a filter.
Parts of a filter
A filter consists of criteria based on packet
attributes. A typical filter can match a packet on
any one of the following attributes:
•
The source IP address and subnet mask
(where the packet was sent from)
•
The destination IP address and subnet mask
(where the packet is going)
•
The TOS bit setting of the packet. Certain
types of IP packets, such as voice or multime-
dia packets, are sensitive to delays introduced
by the network. A delay-sensitive packet is
identified by a special low-latency setting called
the TOS bit. It is important for such packets to
be received rapidly or the quality of service
degrades.
•
The type of higher-layer Internet protocol the packet is carrying, such as TCP or UDP

Port numbers

A filter can also match a packet's port number attributes, but only if the filter's protocol type is set to TCP
or UDP, since only those protocols use port numbers. The filter can be configured to match the following:
•
The source port number (the port on the sending host that originated the packet)
•
The destination port number (the port on the receiving host that the packet is destined for)
165