Skoda 2015 Superb Owner's Manual page 221

Tyre wear indicator and wheel replacement
Fig. 236 Principle sketch: Replace tyre tread with wear indicators /
wheels

Read and observe on page 217 first.
Wear indicators
The base of the tread of the tyres contains has a 1.6 mm high wear indicator
» Fig. 236 - . In some countries, different tyre wear rates may apply.
Markings on the walls of the tyres through the letters "TWI", triangular sym-
bols or other symbols identify the position of the wear indicators.
Replacement of wheels
For uniform wear on all tyres, we recommend that you change the wheels ev-
ery 10 000 km according to the scheme
proximately the same life for all the tyres.
After a wheel has been replaced, the tyre pressure has to be adjusted.
In vehicles with tyre pressure monitoring, save tyre pressure
WARNING
You must have your tyres replaced with new ones at the latest when the
■
wear indicators have been worn down.
Worn tyres impair necessary adhesion to the road surface, particularly at
■
high speeds on wet roads. This could lead to "aquaplaning" (uncontrolled
vehicle movement – "swimming" on a wet road surface).
» Fig. 236- . You will then obtain ap-
values» page
Tyre damage

Read and observe
We recommend checking your tyres and wheel rims for damage (punctures,
cuts, splits and bulges, etc.) on a regular basis.
Remove any foreign objects in the tyre tread immediately (e.g. small stones).
Foreign bodies which have penetrated into the tyre (e.g. screws or nails)
should not be removed and seek help from a specialist garage.
WARNING
Never drive with damaged tyres – risk of accident.
CAUTION
The tyres must be protected from contact with substances such as oil, grease
and fuel, which could damage them. If the tyres come into contact with these
substances, then we recommend you have this checked out in a specialist
workshop.
Unidirectional tyres

Read and observe
The direction of rotation of the tyres is marked by arrows on the wall of the
tyre.
The indicated direction of rotation must be adhered to in order to ensure the
optimal characteristics of these tyres.
These characteristics mainly relate to the following.
183.
▶
Increased driving stability.
▶
Reduced risk of aquaplaning.
▶
Reduced tyre noise and tyre wear.
Spare wheel

Read and observe
A yellow warning label is always displayed on the rim of the temporary spare
wheel.
on page 217 first.
on page 217 first.
on page 217 first.

219
Wheels