Speed Limiter - Skoda 2015 Superb Owner's Manual

Note
During control, speed can be increased by pressing the accelerator pedal. Re-
■
leasing the accelerator pedal will cause the speed to drop again to the set
speed.
By pressing the button » Fig. 198
D
■
and the Speed Limiter is activated.

Speed Limiter


Introduction
This chapter contains information on the following subjects:
Operation
Operation description
The Speed Limiter limits the maximum driving speed to the set speed limit.
This limit can only be exceeded by depressing the accelerator pedal fully.
The condition in which the Speed Limiter monitors a potential set speed limit
excess is referred to as Regulation.
WARNING
The general information relating to the use of assistance systems must be
observed » page 142, in section Introduction.
Operation
Fig. 199 MAXI DOT display (monochrome): Examples of Speed Limiter sta-
tus displays
162
Driving
during the regulation this is cancelled
Fig. 200 Segment display: Examples of Speed Limiter status displays

Read and observe
162
163
Status display of the Speed
Speed limit is set, control is inactive (in the colour display the digits of

speed limits is shown in grey).
Control active (in the colour display the digits of the speed limits are high-

lighted).
No speed limit set.

System fault - seek assistance from a specialist garage immediately.

Basic requirements for start of control
The Speed Limiter is activated.

The current speed is higher than approx. 30 km/h.

on page 162 first.
Limiter» Fig. 199, » Fig. 200