Table of Contents
Advertisement
Set distance to the vehicle ahead.
3
Vehicle detected (control deactivated).
4
ACC status indications
» Fig. 203
Regulation is inactive (in the colour display the digits of speed limits is
shown in grey).
Regulation active - no vehicle detected (in the colour display the digits of
the speed limits are highlighted).
Regulation deactivated - no speed stored.
Regulation active - vehicle detected (in the colour display the digits of the
speed limits are highlighted).
Note to reduce speed
If the delay of the ACC is insufficient in relation to the vehicle in front, in the
instrument cluster, the warning light
following message.
Apply the brake!
Regulation according to the vehicle in the adjacent lane
During regulation your vehicle may be regulated according to the vehicle in the
adjacent lane.
This could occur at speeds above about 80 km / h when your vehicle is moving
faster than the vehicle in the adjacent lane on the driver's side. The display
shows the detected vehicle is in the adjacent lane.
Note
Some ACC notifications in the display of the instrument cluster may be hidden
by notifications for other functions. An ACC notification automatically appears
for a brief moment when there is a change in status of the ACC.
Automatic stop-start
Read and observe
on page 163 first.
Vehicles with an automatic transmission can decelerate to a standstill and
start moving again using the ACC.
Decelerate to a standstill
If a vehicle ahead decelerates to a standstill, the ACC will also decelerate your
vehicle to a standstill.
lights up and the display shows the
Starting to drive again after a holding period
As soon as the vehicle ahead starts moving again after a holding period, your
vehicle will also move and the speed will continue to be regulated.
If the preceding vehicle starts moving again after a long break, then to contin-
ue the regulation press the accelerator pedal or lever to position ad-
just» page
165, Operation Overview.
Operation Overview
Fig. 204 Operating lever
Read and observe
on page 163 first.
Overview of ACC functions operated with the lever
Activate ACC (regulation deactivated)
1
Start control (resume) / increase speed by 1 km/h at a time
2
(sprung position)
Interrupt control (sprung position)
3
Deactivate ACC
4
Increase speed by 10 km/h at a time
5
Decrease speed by 10 km/h at a time
6
Set proximity level
A
Start control (adopt current speed) / Reduce speed by 1 km/h at
B
a time
Note
If the lever is set
» Fig. 204
from the position directly into the sprung posi-
tion, the current speed is stored and the control process is started.
» Fig. 204
165
Assist systems
Advertisement
Chapters
Table of Contents
