Registering A Unit - Panasonic KX-TGP500 User Manual

Registering a Unit

Registering a unit
Operating additional units
Additional handsets
Up to 6 handsets can be registered to the base
unit.
Important:
L The additional handset model recommended for
use with this unit is noted on page 5. If another
handset model is used, certain operations
(Ringer settings, phonebook, etc.) may not be
available.
Registering a handset to the base
unit
The supplied handset and base unit are pre-
registered. If for some reason the handset is not
registered to the base unit (for example, _ is
displayed even when the handset is near the base
unit), re-register the handset.
1
Handset:
{MENU} (centre of joystick) i
{#}{1}{3}{0}
2
Base unit:
■ KX-TGP500:
Press and hold {ALL} for about 4 seconds
until the STATUS indicator flashes in red.
■ KX-TGP550:
Press and hold {ALL} for about 4 seconds
until the registration tone sounds and the
STATUS indicator flashes in red.
L If all registered handsets start ringing, press
the same button to stop. Then repeat from
step 1.
L The next step must be completed within 90
seconds.
3
Handset:
{OKL}
4
Wait until "Enter Base PIN" is displayed.
i Enter the base unit PIN (default: "0000").
i Press {OK}, then wait until a long beep
sounds.
L If you forget your PIN, contact your phone
system dealer.
L When the handset has been registered
successfully, _ will change to w.
42
Note:
L When you purchase an additional handset, refer
to the additional handset's installation manual
for registration.
Deregistering a handset
A handset can cancel its own registration (or the
registration of another handset) that is stored to
the base unit. This allows the handset to end its
wireless connection with the system.
Y Handset
1
{MENU} (centre of joystick) i
{#}{1}{3}{1}
2
{3}{3}{5} i {OK}
3
{V}/{^}: Select the desired unit. i
{SELECT}
4
{V}/{^}: "Yes" i {SELECT}
L When you cancel a different handset than
: Base unit
Available for: KX-TGP550
1
Press and hold {ALL} until the registration
tone sounds and the STATUS indicator
flashes in red.
L If all registered handsets start ringing, press
2
Press and hold the handset number ({1} –
{6}) that you want to cancel until a
confirmation tone sounds.
Increasing the range of the base unit
You can increase the signal range of the base unit
by using a DECT repeater. Please use only the
Panasonic DECT repeater noted on page 5.
Contact your phone system dealer for details.
Important:
L Before registering the repeater to this base unit,
you must turn the repeater mode on. When you
set the repeater mode to "On" (page 43), the
sound is changed from high quality (G.722) to
normal quality (G.711 µ-law, G.711 A-law, G.726
(32k), G.729A) even if calls are not made via a
repeater. Contact your phone system dealer for
details.
Document Version 2012-08
the one you are now using, press {OFF} to
exit.
the same button to stop. Then repeat this
step.