Table of Contents
Advertisement
Installing a hot-swap power supply
Statement 8
CAUTION:
Never remove the cover on a power supply or any part that has the following label attached.
Hazardous voltage, current, and energy levels are present inside any component that has this
label attached. There are no serviceable parts inside these components. If you suspect a
problem with one of these parts, contact a service technician.
34
IBM® xSeries 250: Installation Guide
Before you continue with the power supply-installation procedure, review the
following.
Notes:
1.
During normal operation, each power supply bay must have either a power
supply or filler panel installed for proper cooling.
2.
Before you install a power supply in the right-most power supply bay, you must
disconnect the cable-management arm. You can reconnect the cable-management
arm after installing the power supply.
If you install or remove a power supply, observe the following precautions:
The illustrations in this document might differ slightly from your hardware.
Attention: When you handle static-sensitive devices, take precautions to avoid
damage from static electricity. For details on handling these devices, see "Handling
static-sensitive devices" on page 8.
Advertisement
Table of Contents
