IBM eServer 250 xSeries Installation Manual page 42

12. Slide the hot-swap hard disk drives back into place in the drive bays. If you need
13. Reinstall fan assembly 1 in the server.
14. Reconnect the shuttle.
15. If you disconnected the SCSI cable from the ServeRAID adapter in step 3 on page
16. If you have other options to install or remove, do so now; otherwise, go to
30
IBM® xSeries 250: Installation Guide
to install additional hot-swap drives, do so now (see "Installing a drive in a hot-
swap bay" on page 31). You can connect a maximum of 10 hard disk drives to the
SCSI backplane.
Note: After you connect these hard disk drives to the SCSI backplane, the
backplane sets the SCSI IDs for the backplane and the hard disk drives.
Refer to the User's Reference on the IBM xSeries Documentation CD for
additional information.
Retaining lever
(unlocked position)
Pin
a. Align the two shuttle pins with the holes on each side of the rear of the
chassis, and disengage the retaining levers from the notches on the chassis.
b. Move the retaining levers toward the front of the server, and secure the
retaining levers in the horizontal (locked) position.
26, reconnect the SCSI cable to the adapter.
"Completing the installation" on page 36.
Retaining lever
(locked position)
Pin