Table of Contents
Advertisement
Installing adapters
Non-hot-plug PCI slots
1-2 (on PCI bus A)
External Attention LEDs for
Internal Attention LEDs for
This section describes how to install hot-plug and non-hot-plug PCI adapters. Before
you continue with the adapter-installation procedure, review the following:
•
Slots 1 and 2 support 3.3 V and universal non-hot-plug PCI adapters only.
•
Slots 3 through 6 support 5.0V and universal PCI adapters.
Note: Universal PCI adapters support both 3.3V and 5.0V operation.
•
The system scans PCI slots 1 through 6 to assign system resources; then, the
system starts (boots) the PCI devices in the following order: processor and I/O
board devices, slots 1 and 2, and then slots 3 through 6.
•
You can install hot-plug PCI adapters in PCI slots 3 through 6. You can also install
non-hot-plug PCI adapters in these slots.
Note: The illustrations in this document might differ slightly from your hardware.
hot-plug slots
hot-plug slots
Power LEDs
for hot-plug slots
Hot-plug PCI slots
3-6 (on PCI bus B)
Chapter 2. Installing options
11
Advertisement
Table of Contents
