Table of Contents
Advertisement
9450 Operator's Handbook
Removing Backing Paper ––––––––––––––––––––––––––––––––––––
To remove excess backing paper:
1. Tear the backing paper a few inches away from the
Do Not tear it against the support frame.
n
2. Gently pull the backing paper in the printer to make sure it
Printing in Continuous Mode ––––––––––––––––––––––––––––––––
In Continuous mode (the default), the printer prints a strip of
supply. Supplies may be strips of labels, tags, or thermal
paper.
The LED indicator is solid amber in Continuous mode. Ask
n
your System Administrator to set the mode, if necessary.
To print in Continuous mode:
1. Load the supplies for Non-peel mode. See Chapter 2,
2. Send the print job.
3. Press [Feed]. When printing stops, press [Feed] again to
4. Cut the supply and remove the strip.
Pausing the Printer –––––––––––––––––––––––––––––––––––––––––
To pause the printer while printing in Continuous mode, press
[Feed]. To resume printing the current print job, press [Feed]
again.
Clearing a Print Job –––––––––––––––––––––––––––––––––––––––––
To cancel the current print job manually, press and hold [Feed]
for 3 to 5 seconds.
4-2
support frame.
is tight.
"Loading Supplies."
advance the supply.
Advertisement
Table of Contents
