Examples Of Operating Cycles; Sewing Shoulder Seams - Pfaff 3827-4/33 Instruction Manual

Sewing
10

Examples of operating cycles

.03
10

Sewing shoulder seams

.03.01
Preparation
1st shoulder seam
10 - 3
Press key F1
Fig. 10 - 01
Carry out all steps as described in Chapter 9 Setting up.
If necessary, call up programmed sewing (shoulder seams).
Switch on the backtack function.
Switch on the thread trimming function.
Press +/- key 1 to set the number of stitches, after which the fullness is switched on
automatically (seam segment 1).
Press +/- key 2 to set the number of stitches, which are still to be sewn with the pre-set
amount of fullness, after the sensor has recognized the edge (seam segment 3).
The value for seam segment 2 is calculated automatically. The seam length depends on
the size, the seam end is recognized by the sensor.
1st shoulder seam
1 2 3
Seam segment 4 = mirror image of seam segment 3
Seam segment 5 = mirror image of seam segment 2
Seam segment 6 = mirror image of seam segment 1
10 1 3
1 2
nd
2 shoulder seam
st
(mirror image of 1
shoulder seam)
4 5
6