Section 7: Removing The Door; Remove The Horizontal Access Panel; Installing The Front Door - Montigo H38DF-CLCR Installation & Maintenance Manual

H(L)38DF-CLCR Corner Gas Fireplace
Section 7: Removing the Door
Removing the Front door:
The H*38C* Front door is removed in a few simple steps. Follow these below to
remove the Horizontal access panel, unlatch the door buckles and, remove the door.
Replace in reverse order. The smaller Side door is bolted in place.
Remove the Horizontal Access Pan
Step 1:
Remove the Horizontal cover
by placing fingers in both finger
holes, then pushing away from
you and lifting out. Place it
aside during maintenance or
cleaning.
Install in reverse order.
Figure 26. Removing and installing the the Horizontal Acess Panel
Step 2:
Locate the Door Buckles:
Door buckles
Figure 26a. Locate the door buckles.
Step 3: Release the Door Buckles
Hand-hold
Figure 26b. Door buckle Tool
Step 4:
Firmly grasp hand-hold
end of Door buckle tool
and place the machined
end in the slot under door
frame. (as shown)
Figure 26c.
Page 18
Installation
el:
Finger Holes
Installed Gas
Valve Cove r
Small glass door
afixed to frame
with hardware.
Door Latch Slot
Door Latch Hook
1
Step 5:
Ensure the tool is firmly
in the lower end of the
slot, (as shown), Then pull
toward you (Caution: hold
the tool securely).
Figure 26d.
Step 6:
Pull hard if necessary to
release the spring ten-
sion. (Caution: The latch
springs back with force,
hold the tool securely).
Figure 26e.
Step 7:
Remove the tool from
the latch slot. Ensure the
latches are hanging freely,
the hook end is released
from the bottom of the door.
(Repeat all 4-steps for the
remaining latches).
Figure 26f.
Step 8:
Removing the Door:
Grasp the Door on either side, usually midway and lift upward, lift the door
carefully up and away from the front of the fireplace. See Figures 26g. Place
the Door aside in a safe place while maintenance and / or cleaning is being
performed.
Figure 26g. Removing and installing the glass door.

Installing the Front Door:

To install the door, hook the top edge of the door frame into place. Lower the door
into position and follow the previous steps shown in reverse order.
Hook the top edge of the door frame into place. Lower and rest the door frame in
place and fasten the buckles.
2
3
4
XG0213 - 020111