Honeywell; Lighting Instructions; To Turn Off Gas To Appliance - Montigo H38DF-CLCR Installation & Maintenance Manual

Honeywell

a.
This appliance has a pilot which must be lighted by hand. When lighting the
pilot, follow these instructions exactly.
B. BEFORE LIGHTING smell all around the appliance area for gas.
Be sure to smell next to the floor because some gas is heavier than
air and will settle on the floor.
What To Do If You Smell Gas:
Do not try to light any appliance.

Do not touch any electrical switch; do not use any phone in your building.

1. STOP! Read the safety information above on this label.
2.
Flip down the door on the bottom of the faceplate.
3. Push in gas control knob and turn clockwise
4.
Wait five (5) minutes to clear out any gas. Smell for gas, including near the
floor. If you then smell gas, STOP! Follow "B" in the safety information above on this
label. If you don't smell gas, go to the next step.
5. Locate pilot burner and follow steps below.
6. Turn knob on gas control counterclockwise
7.
Push in gas control knob completely and hold. Light with Piezo Igniter button.
Continue to hold the control knob in for about (1) minute after the pilot is lit. Release
Hi/Lo control knob
Gas control knob
(Shown in "Off" position)
1. Turn off remote switch.
2. Flip down the door on the bootom of the faceplate.
XG0213 - 020111
Operation
FOr YOur SAFeTY - reAD BeFOre LIGHTInG:
XW2008

LIGHTInG InSTruCTIOnS:

to "OFF."
to "PILOT."
NOTE: Gas control knob cannot be turned from

TO Turn OFF GAS TO AppLIAnCe:

WARNING
If the information in these instructions is
not followed exactly, a fire or explosion
may result causing property damage,
personal injury or death.
Immediately call your gas supplier from a neighbour's phone. Follow the gas

supplier's instructions.
If you cannot reach your gas supplier, call the Fire Department.

C. Use only your hand to push in or turn the gas control knob. Never use tools. If
the knob will not push in or turn by hand, don't try to repair it, call a qualified service
technician. Force or attempt to repair may result in a fire or explosion.
D.
Do not use this appliance if any part has been under water. Immediately call
a qualified service technician to inspect the appliance and to replace any part of the
control system, and any gas control which has been under water.
the knob and it will pop back up. Pilot should remain lit. If it goes out repeat steps 3
through 8.
If knob does not pop up when released. Stop and immediately call your service

technician or gas supplier.
If the pilot will not stay lit after several tries, turn the gas control knob to "OFF"

and call your service technician or gas supplier.
8. Push in gas control knob and turn counterclockwise
9. Flip up the faceplate door.
10.Turn on remote switch to ignite fire.
"PILOT" to "OFF" unless knob is pushed
in slightly. Do not force.
3. Push in gas control knob slightly and turn
force.
4. Flip up the faceplate door.
H(L)38DF-CLCR Corner Gas Fireplace
to "ON."
clockwise to "Off". Do not
Page 23