Etb Unit; Removing The Etb Unit; Etb Motor; Preparation For Removing The Etb Motor - Canon i-SENSYS LBP5300 Series Service Manual

When the developing estrangement drive unit is properly set to its home
position, rotating the gear [2] does not make the gears [4] rotate and also
there will be no sense of resistance when rotating the gear [2].
2. Alignment of Developing Estrangement Drive Unit in Mounting
Tighten the 2 screws [1] to the developing estrangement drive unit[3] and
tighten the screw [2] halfway, then confirm the alignment of the gears [4]
and [5].
How to Confirm the Alignment of the Gear [4]
The gear [3] in the developing estrangement drive unit [1] has a tooth that
is smaller than the others. Make sure the smaller tooth is aligned with the
elongate hole [2] (home position). Also, as shown in [4] in the picture,
make sure the triangle and the elongate hole of the gear lie right next to
each other.
How to Confirm the Alignment of the Gear [5]
The gear [3] in the developing estrangement drive unit [1] has a tooth that
is smaller than the others. Make sure the smaller tooth is aligned with the
elongate hole [2] (home position). Also, as shown in [4] in the picture,
make sure the triangle and the elongate hole of the gear lie right next to
F-3-104
F-3-105
F-3-106
F-3-107
each other.

3.3.2 ETB Unit

3.3.2.1 Removing the ETB Unit

/ i-SENSYS LBP5360 / i-SENSYS LBP5300
1) Open the front cover.
2) While pressing the ETB lock lever [1], remove the ETB unit [2].

3.3.3 ETB Motor

3.3.3.1 Preparation for Removing the ETB Motor

/ i-SENSYS LBP5360 / i-SENSYS LBP5300
1) Remove the ETB unit. (page 3-15)[Removing the ETB Unit]

3.3.3.2 Removing the ETB Motor

/ i-SENSYS LBP5360 / i-SENSYS LBP5300
1) Remove the duplexing delivery assembly [1].
- 2 screws [2]
2) Remove the ETB right cover [1].
- 3 screws [2]
- 5 claws [3]
Chapter 3
F-3-108
F-3-109
F-3-110
0013-9871
0014-4835
0014-4837
3-15