Ndis 4.0 Windows Driver Messages - IBM eServer 200 xSeries User Reference Manual

Table 13. NetWare driver messages for the Ethernet controller.
Message
Please unload all LAN drivers before
unloading AFT.NLM.

NDIS 4.0 Windows driver messages

This section contains the error messages for the NDIS 4.0 drivers. The explanation
and recommended action are included with each message.
Table 14. NDIS (Windows NT) driver messages for the Ethernet controller.
Error code (hex)
0x00 Explanation: The driver could not register the specified interrupt.
Action: Using the Configuration/Setup Utility program, make sure that a PCI interrupt is assigned to
your Ethernet card, and that Ethernet is enabled.
0x01 Explanation: One of the PCI cards did not get the required resources.
Action: Using the Configuration/Setup Utility program, make sure that a PCI interrupt is assigned to
your Ethernet card, and that Ethernet is enabled.
0x02 Explanation: Bad node address (multicast address).
Action: Make sure the locally administered address is valid, if one is specified. The address cannot
be a multicast address.
0x03 Explanation: Failed self-test.
Action: Make sure a cable is attached to the Ethernet connector. If the problem persists, call for
service.
0x0D Explanation: Could not allocate enough memory for transmit queues.
Action:
From the Windows NT desktop, click Start → Control Panel → Networks → Adapters.
1.
2. Select your IBM Ethernet adapter from the list.
Click Properties → Advanced.
3.
4. Lower the resource values that apply to the transmit queue.
0x0E Explanation: Could not allocate enough memory for receive queue.
Action:
From the Windows NT desktop, click Start → Control Panel → Networks → Adapters.
1.
2. Select your IBM Ethernet adapter from the list.
Click Properties → Advanced.
3.
4. Lower the resource values that apply to the receive queue.
0x0F Explanation: Could not allocate enough memory for other structures.
Action:
From the Windows NT desktop, click Start → Control Panel →Networks → Adapters.
1.
2. Select your IBM Ethernet adapter from the list.
Click Properties → Advanced.
3.
4. Lower the value for the resource named in the message.
Explanation: An attempt was made to unload the AFT.NLM module before
unloading the adapter driver.
Action: Unload the adapter driver before unloading the AFT module.
Description
Description
Chapter 6. Solving problems
87