IBM eServer 200 xSeries User Reference Manual page 55

Attention: When you handle static-sensitive devices, take precautions to avoid
damage from static electricity. For details on handling these devices, see "Handling
static-sensitive devices" on page 27.
1. Read the information in "Preinstallation steps (all bays)" on page 40 and "Safety
information" on page 28.
2. Turn off the server and peripheral devices and disconnect the external cables and
power cords; then, remove the side cover (see "Removing the side cover" on page
33 for details).
3. Remove the support-bracket assembly and disconnect the fan cable from the
connector (SYSFA3) on the system board. See "Removing the support-bracket
assembly" on page 34 for details. See "System board internal cable connectors"
on page 24 for the location of the fan cable connector.
4. Use a screwdriver to gently pry the filler panel and EMC shield away from the
server.
Note: If you are installing a drive that is a laser product, observe the following
safety precaution.
Statement 3
CAUTION:
When laser products (such as CD-ROMs, DVD drives, fiber optic devices, or
transmitters) are installed, note the following:
• Do not remove the covers. Removing the covers of the laser product could
result in exposure to hazardous laser radiation. There are no serviceable
parts inside the device.
• Use of controls or adjustments or performance of procedures other than
those specified herein might result in hazardous radiation exposure.
Danger
Some laser products contain an embedded Class 3A or Class 3B laser diode. Note
the following. Laser radiation when open. Do not stare into the beam, do not view
directly with optical instruments, and avoid direct exposure to the beam.
5. Touch the static-protective package containing the drive to any unpainted metal
surface on the server; then, remove the drive from the package and place it on a
static-protective surface.
6. Set any jumpers or switches on the drive according to the documentation that
comes with the drive.
7. Install the drive:
• If you are installing a 5.25-in. drive in bay 2, push the drive into the bay. Then,
use the two screws that come with your option to attach the drive to the drive
cage.
• If you are installing a 3.5-in. drive in bay 2, you must attach the 5.25-in.
conversion kit, supplied with your option, to the 3.5-in. drive.
8. Cable the drive:
Chapter 5. Installing options
41