IBM eServer 200 xSeries User Reference Manual page 59

assembly" on page 34 for details. See "System board internal cable connectors"
on page 24 for the location of the fan cable connector.
4. Install the DIMM:
a. If you are installing a DIMM in connector 1, remove the AGP video adapter.
Remove the AGP video adapter only if you are replacing the DIMM in
connector 1. See "System and PCI extender-board option connectors" on
page 24 for the location of the AGP slot.
b. Open the retaining clip on each end of the DIMM connector.
Attention: To avoid breaking the retaining clips or damaging the DIMM
connectors, open and close the clips gently.
c. Touch the static-protective package containing the DIMM to any unpainted
metal surface on the server. Then, remove the DIMM from the package.
d. Turn the DIMM so that the pins align correctly with the connector.
e. Insert the DIMM into the connector by aligning the DIMM edges with the slots
at each end of the DIMM connector. Firmly press the DIMM straight down into
the connector by applying pressure on both ends of the DIMM simultaneously.
Be sure that the retaining clips snap into the locked position when the DIMM
is firmly seated in the connector.
f. If a gap exists between the DIMM and the retaining clips, the DIMM has not
been properly installed. In this case, open the retaining clips and remove the
DIMM; then, reinsert the DIMM.
g. If you removed the AGP video adapter, reinstall it now. See "Installing an
adapter" on page 36.
5. If you have other options to install or remove, do so now.
6. Replace the support-bracket assembly and reconnect the fan cable to the
connector (SYSFA3) on the system board. See "Removing the support-bracket
assembly" on page 34 for details. See "System board internal cable connectors"
on page 24 for the location of the fan cable connector.
7. Replace the side cover. See "Installing the cover" on page 50.
8. Reconnect the external cables and power cords; then, turn on the peripheral
devices and the server.
If you want to remove a DIMM, reverse these steps.
Chapter 5. Installing options
45