Removing The Side Cover - IBM eServer 200 xSeries User Reference Manual

5. Rotate the foot outward until the foot locks into place.
6. Complete steps 2 through 5 for each foot.

Removing the side cover

The following information describes how to remove the side cover.
Note: The illustrations in this document might differ slightly from your hardware.
Complete the following steps to remove the side cover of the server.
1. Review the information in "Before you begin" on page 26 and the safety
2. Turn off the server and peripheral devices and disconnect all external cables and
3. If necessary, unlock the server cover.
4. Pull out on the cover-release latch, which will slide the cover toward the rear of the
To replace the side cover, see "Installing the cover" on page 50.
Note: When you need to access the inside of the server to install options, you
might find it easier to lay the server on its side. If you do so, make sure the
feet are in the horizontal position (see the previous steps). Otherwise, the
feet might break off the server because of the weight of the server.
Cover-release
latch
precautions listed in Statement 1 and Statement 5 in "Safety information" on page
28.
power cords.
server about 12.7 mm (0.5 in.). Then, remove the cover from the server and set it
aside.
Key lock
Chapter 5. Installing options
33