Performing Distance Correction During Cutting - Roland VersaUV LEC-300 User Manual

5-5 Optimizing Printing to Match Media Thickness
To make the setting for the correction value even more accurate, we recommend carrying out the following before printing
the test pattern.
 After loading the media, use
 Set the print-start position near the center of the media.
 P. 79, "Setting the Print-start Position"
Note, however, that you can also make this setting on the computer (by, for example, choosing the media type in the soft-
ware RIP you are using). When you have made the setting on the computer, the computer's setting is used and the printer's
setting is ignored.
Default Setting
[SETTING]: 0.00%

Performing Distance Correction During Cutting

Procedure

MENU
CUTTING MENU

CUTTING MENU
CALIBRATION

FEED SETTING
0.00%

CALIBRATION
SCAN SETTING

SCAN SETTING
0.00%

W 736mm
SETUP SHEET
ROLL
94 Chapter 5 Feature Reference
to feed out the media by about one meter.
Print-start position
Press
Press
Press
Press
Press
Use
0.00%
Press
Press
Press
Press
Use
0.00%
Press
Press
Press
"
.
several times.
.
twice.
twice.
to make the setting for the correction value.
to enable the setting for [FEED SETTING].
.
.
.
to make the setting for the correction value.
to enable the setting for [SCAN SETTING].
.
to go back to the original screen.
Approx. 1 m