Making Various Adjustments For Cutting; Making The Cutting Conditions Set On The Machine Take Precedence; Fine-Tuning The Cutting Conditions - Roland VersaUV LEC-300 User Manual

5-6 Making Various Adjustments for Cutting

Making the Cutting Conditions Set on the Machine Take Precedence

Procedure

MENU
CUTTING MENU

CUTTING MENU
CUTTING PRIOR

CUTTING PRIOR
COMMAND

W 736mm
SETUP SHEET
ROLL
Description
You can also make the settings for the cutting conditions using the computer. By default, the settings made with the computer
take priority. To make the cutting conditions set on the machine take priority, either turn off the settings of the computer
or make the setting described above.
Default Setting
[CUTTING PRIOR]: COMMAND

Fine-tuning the Cutting Conditions

Procedure

FORCE
50gf
Use

W 736mm
SETUP SHEET
ROLL
Description
This enables you to check and verify the settings for the cutting conditions using cutting-test results.
P. 45, "Performing a Cutting Test"
[FORCE]: This sets the force (pressure) of the blade.
[SPEED]: This sets the speed of cutting.
[OFFSET]: This makes the blade-offset setting for the blade. Enter the listed offset value for the blade. (The offset value for
the included blade is 0.25 mm.)
[UP-SPEED]: This sets the blade's up speed during cutting (the speed at which the blade travels when it moves to the next
cutting line after cutting one cutting line). If the media comes loose during no-load feed and the blade damages the surface
of the media, reduce the speed.
96 Chapter 5 Feature Reference
Press
Press
Press
Press
Press
Use
MENU
Press
Press
Press
Press
60gf Use
set.
to enter the value.
Press
screen.
.
several times.
.
twice.
.
to select "MENU."
to enable the setting.
.
to go back to the original screen.
.
to choose the cutting condition you want to
to enable the setting and go back to the original