Remote Access - AT&T E2727B User Manual

Dial your telephone number from
1.
any touch-tone phone.
When system answers, enter your
2.
two-digit remote access code (19
unless you have changed it).
Enter remote commands
3.
(see list at right).
Hang up to end call and save all
4.
undeleted messages.
NOTE: If you pause for
more than 10 seconds dur-
ing remote access, you will hear a
help menu listing all features &
commands. If you issue no com-
mand for another 20 seconds, the
call will end automatically.
Answering System Operation

Remote access

Use the remote access feature to check your messages
while you are away by calling your home phone num-
ber from any touch tone phone outside of your home.
When the answering system picks up, simply enter a
two digit security code to then access your messages.
This code is set at 19 by default; see page 32 to change
it.
Play all messages
1
Play new messages
2
Delete the message
3
33
Repeat or go back
4
Stop
5
Skip to next message
6
Review announcement
#7
Record announcement
*7
to begin recording
5
to stop recording
Record memo
8
to begin recording
5
to stop recording
Review remote access code
#9
Change remote access code
*9
Help menu
*5
Turn system off
0
Turn system on
0
36
Press to listen to all messages.
Press to listen to new messages.
Press during playback to delete current
message. Press 3 twice to delete all old
messages while it is in remote access
idle mode (message not playing back).
Press during the caller's message to
repeat the message. Press during the
beginning of the day and time announce-
ment to go back to the previous mes-
sage.
Press to stop any operation (stop play-
back, stop recording).
Press to skip current message and
advance to next message.
Press to review current outgoing
announcement.
Press * 7, wait for beep, then begin
speaking. Press 5 to stop recording and
listen to playback of new announcement.
Press 8, wait for beep, then begin
speaking. Press 5 to stop recording.
Press # 9 to review remote access
code.
Press * 9 to change remote access
code, then enter desired remote access
code from 10-99.
Press to hear list of features & com-
mands.
Press to turn off answering system.
Incoming calls will no longer be
answered.
If off, system will answer after 10 rings.
Enter your access code, then press 0 to
turn on.