Remote Control Operation - Heat & Glo T-HVBI-AUB Owner's Manual

2.4 REMOTE CONTROL OPERATION

Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be voided by,
the following actions:
• Installation and use of any damaged system compo-
nent.
• Modification of the system component.
• Installation other than as instructed by Hearth & Home
Technologies.
• Installation and/or use of any component part not
approved by Hearth & Home Technologies.
Any such action may cause a fire hazard.
• Read, understand and follow these instructions for
safe installation and operation.
Fireplace Specific Information
Standard fireplace features vary. Consult the installa-
tion manual for available options.
The included AUX300CE receiver provides additional
features: Fan control and two Aux functions.
The RC300AU remote control system functions in-
clude: On/Off, Thermostat Mode, Timer Countdown,
and Flame Adjustment (for fireplaces with variable
flame).
Kit Contents
RC300AU
• RC300AU Transmitter
• AAA Batteries (3)
• Wall Holder
• Drywall Anchor (2)
• Screws (2)
34 Heat & Glo • ST-HVBI-AUB • 2082-980 Rev. R • 9/15
Introduction
The RC300AU multifunctional remote control is
designed to control pilot light, flame height, blow-
er speed, and up to two 220/240 VAC auxiliary
functions on your gas fireplace. The RC300AU is
equipped with thermostat functions which can au-
tomatically control the temperature in the room in
which it is installed. The control is only for use with
the Hearth & Home Technologies IntelliFire™ Plus
system (IPI). The AUX300CE module is rated for
220/240 VAC, 50-60 Hz, and is required for operation
of this remote control device.
Installation Precautions
The installation of this remote control must be per-
formed by a qualified service technician. This remote
control is tested and safe when installed in accor-
dance with this installation manual. Do not install any
components that may be damaged.
Do not modify, disassemble, or substitute any of the
components included with this kit. Installation of this
unit must be done by a qualified service technician.
Placement of this remote control may affect perfor-
mance. An assessment of the space should be done
prior to installation for optimum performance.
Determine Location
Determine the location for the remote control. The
selected location should be in the same space as
the gas fireplace. Never place this unit in a separate
room. The remote control must be placed within 30 feet
(9.14 m) of the fireplace but should not be exposed to
extreme heat.
The RC300AU is approved for interior installation and
should not be used in exterior applications.
• Keep remote control out of reach of children.