Operation Cautions - Heat & Glo ST-HVBI-AU Installation And Operation Instructions Manual

PILOT
Figure 37
WARNING
HOT SURFACES!
Glass and other surfaces are hot during
operation AND cool down.
Hot glass will cause burns.
• DO NOT touch glass until it is cooled
• NEVER allow children to touch glass
• Keep children away
• CAREFULLY SUPERVISE children in same room as
fi replace.
• Alert children and adults to hazards of high temperatures.
High temperatures may ignite clothing or other
fl ammable materials.
• Keep clothing, furniture, draperies and other fl ammable
materials away.
This appliance has been supplied with an integral barrier
to prevent direct contact with the fi xed glass panel. DO
NOT operate the appliance with the barrier removed.
2.1 OPERATING CAUTIONS
• This appliance may exhibit a slight carbon deposition.
• Do not place articles on or against this appliance.
• Do not use or store fl ammable materials near this
appliance.
• Do not spray aerosols in the vicinity of this appliance
while it is in operation.
• The dress guard is fi tted to this appliance to reduce the
risk of fi re or injury from burns and no part of it should be
permanently removed. For protection of young children
28
IGNITION MODULE
6VDC
NEUTRAL
BATTERY PORT
ON/OFF
SWITCH
GAS LINE
CONNECTED TO
BACK OF VALVE
Heat & Glo • ST-HVBI-AU • 2082-900 Rev. J • 10/10
FLAME SPARKER/
SENSOR
VALVE
REMOTE
CONTROL
ANT.
ON/OFF
WALL SWITCH
IGNITION
MODULE
(6V)
GROUND
THERMOCOUPLE
BLOCK
(CONNECTED TO
BACK OF VALVE)
VALVE
or the infi rm, a secondary guard is required.
• The dress guard must be in place and sealed and the
fi xed mesh trim assembly must be in place on the heater
before the unit can be placed into safe operation.
• Do not use this appliance if any part has been under
water. Immediately call a qualifi ed service technician
to inspect the unit and to replace any part of the
control system and any gas control which has been
underwater.
• Do not operate this appliance with the glass door
removed, cracked, or broken. Replacement of the glass
door should be done by a licensed or qualifi ed person.
Do not strike or slam the glass door.
• The glass door assembly shall only be replaced as a
complete unit as supplied by the gas heater manufacturer.
No substitute materials may be used.
2.2. SAFETY & LIGHTING INFORMATION
Follow SAFETY INFORMATION and LIGHTING IN-
STRUCTIONS to light the appliance.
By design, the fl ame pattern will not be identical from unit
to unit. Additionally, fl ame pattern may vary depending on
installation type and weather conditions.
NOTE: THE TIPS OF THE FLAMES SHOULD NEVER
HIT THE TOP OF THE FIREBOX.
These gas models have remote control valve which allow
you to increase or decrease the height of the main burner
fl ames. Push the button to increase the fl ame height
and the button to decrease the fl ame height.
HOT
PLUG IN