Table of Contents
Advertisement
Rough surfaces collect contaminants that can be transferred to the interior of the mouse
by the ball. Rough surfaces can also cause the pads located on the bottom of the
mouse to prematurely wear. A deeply pitted surface could cause erratic operation of the
mouse. The surface you use should be free from spills, dirt, dust, lint, wax, eraser dust,
and other foreign matter.
To care for the mouse:
v Inspect the work surface for spills or other contaminants.
v Dust the work surface.
v If you are using a paper pad, inspect it for wear and replace it if necessary.
Cleaning the Mouse
Use the following steps to clean the mouse:
1. Remove the retaining ring by turning it counterclockwise, in the direction of the
arrow, as shown in the illustration.
2. Remove the ball.
3. Inspect the ball for contaminants. Wipe it clean with a dry, lint-free cloth.
4. If the ball is dirty, wash it in warm, soapy water. Rinse and wipe the ball with a
lint-free cloth until dry.
5. Inspect the ball cavity in the mouse for foreign materials. If there are any foreign
materials, remove them.
6. Replace the ball.
7. Replace the retaining ring on the mouse and align it with the open slots in the ball
cavity.
8. Turn the retaining ring clockwise until the open slots are covered and you hear the
ring snap into place.
Retaining Ring
Ball
Cavity
Chapter 2. Using the System
15
Advertisement
Table of Contents
