Table of Contents
Advertisement
-s
Fibre Channel RAID Service Aids
The Fibre Channel RAID (Redundant Array Independent Disk) service aids contain the
following functions:
Certify LUN
Certify Spare Physical Disk
Format Physical Disk
Array Controller Microcode Download
Physical Disk Microcode Download
Update EEPROM
Replace Controller
Source of the new microcode. The default is /etc/microcode. Default source
device is disk.
This selection reads and checks each block of data in the LUN (Logical Unit
Number). If excessive errors are encountered the user is notified.
You can run this task from the AIX command line. The syntax of the fastpath
command is as follows: diag -T "certify"
This selection allows the user to certify (check integrity of the data) on drives
that are designated as spares.
You can run this task from the AIX command line. The syntax of the fastpath
command is as follows: diag -T "certify"
This selection formats a selected disk drive.
You can run this task from the AIX command line. The syntax of the fastpath
command is as follows: diag -T "format"
This selection allows the microcode on the Fibre Channel RAID controller to be
updated when required.
You can run this task from the AIX command line. The syntax of the fastpath
command is as follows: diag -T "download"
This selection is used to update the microcode on any of the disk drives in the
array.
You can run this task from the AIX command line. The syntax of the fastpath
command is as follows: diag -T "download"
This selection is used to update the contents of the EEPROM (Electrically
Erasable Programmable Read Only Memory) on a selected controller.
Use this selection when it is necessary to replace a controller in the array.
Chapter 6. Introducing Tasks and Service Aids
121
Advertisement
Table of Contents
