Table of Contents
Advertisement
Step 4
Determine if the operating system is accepting commands.
Is the operating system accepting commands?
NO
YES
Step 5
Diagnostic tests can be run on many resources while the operating system is running.
However, you can obtain more extensive problem isolation by running Online
Diagnostics in Service mode.
Do you want to run the Online Diagnostics in Service mode?
NO
YES
Step 6
This step invokes the Online Diagnostics in concurrent mode.
1. Log in as root user.
2. Enter the diag command.
3. Wait until the Diagnostic Operating Instructions are displayed, or wait for three
minutes.
Are the Diagnostic Operating Instructions displayed without any obvious console
display problems?
NO
YES
146
User's Guide
The system must be turned off in order to run diagnostics.
Verify with the system administrator and users that the system may
be turned off. If so, then turn off the system unit and go to "Step 7" on
page 147.
Go to "Step 5".
Go to "Step 6".
Do the following to shut down your system:
1. At the system prompt, stop the operating system using the
appropriate command for your operating system.
2. After the operating system is stopped, turn off the system unit.
3. 3. Go to "Step 7" on page 147.
Do the following to shut down your system:
1. At the system prompt, stop the operating system using the
appropriate command for your operating system.
2. After the operating system is stopped, turn off the system unit.
3. 3. Go to "Step 7" on page 147.
Go to "Step 10" on page 148.
Advertisement
Table of Contents
