Magnavox MDR868H Owner's Manual page 61

Add Channels
This function lets you add the Channels that were not added by
"Auto Channel Preset" due to the reception conditions during
the initial setup.
2
Select "Add Channels" using [ K/ L ], then
press [ OK ].
• The password will be required if you have locked
Channels. Refer to 'Channel Lock' on page 62.
• Channel search will begin.
3
Press [ OK ] on "Finish" to complete
Channel scan.
• Press [ (EXIT) ] to Exit.
Skip Channels
The Channels Selected here will be Skipped when Selecting the
Channels using [ CH +/− ].
Those Channels can still be Selected using [ the Number
buttons ].
2
Select "Skip Channels" using [ K/ L ], then
press [ OK ].
3
Select the Channel you would like to Skip
using [ K/ L ], then press [ OK ].
• "Watch" that the Channel is not Skipped.
• "Skip" that the Channel is Skipped.
• To reactivate a Skipped Channel, use [ K/ L ] then
press [ OK ].
• Repeat step 2 until you Select all the Channels you
would like to Skip.
• Press [ (EXIT) ] to Exit.
Antenna Out
Set whether you want the Antenna signal to passthrough when
the Power is Off (Standby) mode.
2
Select "Antenna Out" using [ K/ L ], then
press [ OK ].
3
Select a desired item using [ K/ L ], then
press [ OK ].
This unit will passthrough the Antenna
signal when the Power is Off (Standby)
mode.
Old
This unit does not passthrough the
Off
Antenna signal in the Power Off
(Standby) mode.
• If you connect the RF to another device, recommend
to set it "Old".
• If you Select "Old", Power Consumption is high.
Attenuator
To decrease TV Broadcasting signal strength to the proper level.
2
Select "Attenutor" using [ K/ L ], then press
[ OK ].
3
Select a desired item using [ K/ L ], then
press [ OK ].
TV Broadcasting signal strength to the
proper level.
Old
Maintain the current TV Broadcasting
Off
signal strength.
EN
Continued on next page.
EN - 61